Parts for Felco lopper model 20 (F20)

Made in Switzerland.

We've never seen a broken Felco lopper handle, but if some horrible accident does bend or break your F20 lopper handle you can get a replacement handle here. The handle assembly (either side) for the Felco 20 lopper, with the grip and rubber shock absorber The blade is not included.

This grip can be a challenge to install. Soak it in hot water, coat the inside with detergent and use lots of elbow grease. Once you're done it will have been worth the effort. A shiny, spiffy replacement handle grip for you trusty Felco lopper.

Felco blades are nearly indestructible, but a bad twist on hard wood can chip even the hardest steel. Don't let an unfortunate accident take you off the job. Always carry a replacement blade.

Opposite the 200-3 cutting blade, and matching its curve, the hook-shaped anvil blade holds the branch for cutting. Anvil blades should never be sharpened.

These strong pins attach a Felco lopper's cutting and anvil blades to the handles.

Be ready for anything. This pocket-size kit has everything you need for minor repairs to your Felco lopper. Contains two screws (20-6), two nuts (20-7), locking segment (2-16) and locking segment screw (20-11).

Restore your loppers to bouncy, cushioned youth and save your wrists at the same time. Lopper bumpers should be replaced every 2 to 3 years.

Fits all Felco loppers. Contains center bolt (20-8) and nut (20-9).

Used for adjustment and maintenance of Felco pruners and loppers. Just the right shape for tightening or loosening the center nut. The correct thickness for fitting the screw slots on older models. On newer models use the handy hexagon-shaped cut-outs for slip-free adjustment of all the nuts and bolts on your Felco pruner or lopper.